Adjustable Desktop Clampa desk mount for MOZA Flight panels with 60° of tilt

No profile rig needed: your panel on the desk edge, at your angle

The MOZA Adjustable Desktop Clamp is a desk mount for instrument panels and displays in the MOZA Flight line. It clamps onto the edge of a desktop and lifts a panel out of the pile on your desk into the right position in front of you, with no aluminium-profile cockpit required. The tilt joint adjusts through 60°: you set the angle once to suit your height, chair and seating position, then lock it with a screw. The body is made from composite materials and weighs 1.35 kg — enough to keep the assembly steady while you work the toggles and buttons. The mount measures 100 × 138 × 116 mm. The panel bolts to the mounting plate: four M5 screws, four M4 screws, an 8 mm wrench and a 3.0 mm wrench are supplied, so no separate tools are needed. MOZA lists compatibility with the MGX1000 instrument panel, the MA3F and MB7F flight computer displays, the FMP18 panel bundle and the MA3F Electronic Flight Control Modules.

1. 01

   The panel in its place, not on the desk

   Without a mount, MOZA Flight panels and displays usually just lie on the desk: awkward to read, sliding away when you press a switch and crowding the keyboard. This clamp pulls onto the edge of a desktop and lifts the panel into a vertical plane in front of you. No aluminium-profile cockpit has to be built for that.

2. 02

   60° of tilt, locked with a screw

   The joint covers a 60° range, so a panel can stand almost upright or lean noticeably towards you — matched to your height, chair and distance to the monitor. The angle locks with a screw and stays put once set. Changing it again takes a few seconds with the supplied key.

3. 03

   All the hardware is already inside

   The box holds four M5 screws, four M4 screws, an 8 mm wrench and a 3.0 mm wrench — exactly what the compatible MOZA panels need. There is no hunting for the right thread at a hardware shop or matching up bits. The mounting plate's holes and slots let you shift the panel slightly in height during installation.

4. 04

   A 1.35 kg composite body

   The mount is made from composite materials and weighs 1.35 kg at 100 × 138 × 116 mm. The mass works for stability here: flicking a toggle or pressing a button does not set the assembly rocking, and the panel stays where you put it. A thumb screw lets you take the mount off the desk without tools when it is not needed.